Panels – menu items / functions for interacting with HyperMesh. • Sub-panels – divides panel Generally refers to file types other than a HyperMesh binary file. HyperWorks OptiStruct Tutorials and Examples Learn more at The file is necessary for OptiStruct to recognize it as an input file. 3. All files referenced in the HyperMesh tutorials are located in the HyperWorks installation directory under /tutorials/hm/. If the location of your HyperWorks.

Author: Akijin Arashicage
Country: Japan
Language: English (Spanish)
Genre: Business
Published (Last): 5 October 2006
Pages: 25
PDF File Size: 6.39 Mb
ePub File Size: 2.46 Mb
ISBN: 733-2-79095-591-6
Downloads: 51503
Price: Free* [*Free Regsitration Required]
Uploader: Gardanos

The midsurface is created, and the surfaces are organized into a new Middle Surface component.

The active selector advances to N2. On the display toolbar, click Unmask All. Extend a line to a surface edge.

Take a minute to look over the mesh that was created. Remain in the Circles: For the final designed robot, HyperWorks was used for structural analysis to understand whether or not the robot meets requirements, and MotionSolve was extremely useful for practical industrial education that is linked to CAD design.

The main menu pages menu divides the main menu into groups of related functions. Select and unselect elements by using the extended entity selection menu. From the Mask By Config tab menu, select 1 under the Isolate column to display only component collectors.


The proposed structure is fabricated and its performances tutoorials compared with the simulation results obtained from FEKO. For 1st line, pick the vertical line through which the line extended in step 19 passes. Page 4 of 10 control is achieved by supplying the surface generator with some plot elements, which will indicate what the boundaries of the hylerworks surfaces should be.

The higher the number, the lower the mesh quality. Go to the Line Edit panel. The objective is to minimize the compliance for the single subcase. Create a hyperwor,s collector to geometry.

Resource Library

For the anchor button, choose the node ID Go to the find attached sub-panel. The Model browser does not allow you to do this, but you can create assemblies from it.

Select the draw subpanel to set up the draw direction. Enter the edge edit panel in one of the following ways: From the Analysis page enter the OptiStruct panel. Go to the 2-d sub-panel. Right-click the HyperMesh hhyperworks.

The design spaces are the three plates. N1 now has a cyan border indicating it is the active selector. You can create nodes in this manner on lines, surfaces tutotials elements.

From the Model browser, turn off the display of geometry in the component named lvl10 to display only the Middle Surface component.

Tutorials & Downloads

Create a midsurface Visualize the midsurface by using shading options and transparency This exercise uses CAD geometry data for a thin solid clip. Click restore1 hyperwodks bring back the saved view. Elements adjacent to the selected elements are now selected.


For this, click Wireframe Geometry 5. The farther the mouse pointer is from the center of rotation, the quicker the model rotates. Click topology to enter the panel. Make sure the switch is pointing to master. Access hyperworls find panel in one of the following ways: This is because the line is organized into the current component, geometry.

In this presentation, the current state of digitalization of maritime industry, structural rules and evaluation software used for hull structural design will be introduced. You may need to zoom in on the model to select a valid entity. Pick one of the red lines bounding one of the gaps missing surfaces.

Use the Model browser to display the elements in the lvl10 component. Move the component, geometry, to the front in the components list. This is because these components are not active in the Display panel. Enter the objective panel.

Author: admin